NVA P90sa (Stepped Attenuator) Preamplifier

All 6 inputs are identical and hardwired to the selector switch using silver alloy cable with PTFE cover. The output of the switch is routed to the potentiometer and tape socket again with the silver alloy cable. The separate left and right volume controls are a very high quality Shinkoh/Elma 24 step mono attenuator. The signal is routed by using silver alloy cable. There are three sets of output sockets in parallel to facilitate single / bi / tri-amping.

NVA P90sa Specifications:

  • Controls - Left and right volume control and source select

  • Inputs - Six line level and direct

  • Outputs - Three pairs of `pre-outs' for single / bi / tri amp support - plus tape output

  • Dimensions - w360mm x h65mm x d210mm

For turntable use you must use an NVA Phono1 or Phono2 external phono stage or equivalent or buy the P90 version with inbuilt phono stage.

Not all Power Amplifiers are suitable for use with a Passive Pre-Amp and the manufacture should be contacted to assess suitability.

Warranty is for two years parts and labour and after that a further three years it will be repaired on a no profit / cost basis.

NVA P90sa Preamplifier

NVA P90sa Preamplifier - Rear